Authentic Joyetech Ego One CLR Coils (5pack)

  • Sale
  • Rs. 999
  • Regular price Rs. 1,199

Product introduction

5pcs Joyetech eGo One CLR Atomizer Head is the specially designed atomizer head for Joyetech eGo One. With CLR head, you’re able to rebuild it while performance diminishing. Get it to enjoy vape and DIY fun!

Height: 18mm
Diameter: 10mm
Pre-made coil resistance: 1.0ohm, 0.5ohm
Pre-made coil diameter: 0.4mm
Suggested coil resistance: more than 0.3ohm


5pcs Joyetech eGo One CLR Atomizer Head


eGo One CLR comes with
  • 1 x 5pcs Joyetech eGo One CLR Atomizer Head
Simple packing. Customary Packing from the factory, the packing is subject to change without notice.


High quality
Delicate design


5pcs Joyetech eGo One CLR Atomizer Head


Operation Steps
1.Prepare the heating wire. Standard heating wire for example. Take a piece of heating wire of around 60millimeters long and roll the heating wire; Reserve around 8.5mm on one side, and then rotate 5 - 6 circles reserving around 7mm on the other side. Bend a little at bot ends.

2.Install the regulating ring to the atomizer tube and screw it tightly. This ring could adjust the amount of liquid entering.

3.Put the heating wire into the tube, and keep it in the center position.

4.Put the long end into notch, pass the short end through the insulating ring.

5.Install the insulating ring and connection base to the tube.

6.Adjust the position of the heating wire and make the cotton cross the heating coil, cut off the redundant cotton to keep flush with liquid entering notches.

7.Screw on the top cap tightly.

Remark: please drip a few drops of e-juice on the cotton and make sure it is moist before the first use, or it will burn.